Phone #: 800-280-8987
IOGear 4 Port Video Splitterat
Brand: IOGear
Part Number: GVS94


Product Details:
Product Description
The Video Splitter is a signal booster and splitter that is used to take video input from a single source and direct it to four video outputs for monitors using analog signals. The signal boost obtained by using the GVS94 allows you to not only split the signal but to extend the distance so that you can send the signal to about 215 feet away. This is no small feat, your average VGA card, over a standard VGA cable, sends a clear VGA signal approximately 25 feet. Dividing this between other displays reduces the video quality. This is why IOGEARs video splitters are the best choice for allowing you to carry and split the video signal to more that one display with the same quality as the original signal. Bandwidth is the term that is used to describe the signal capacity of these units. In general, bandwidth is directly proportional to the amount of data transmitted per unit of time. Specifically, in analog signals, bandwidth is the difference between the highest-frequency and the lowest frequency components of a givin signal. For example a voice telephone signal has a bandwidth of 3000 Hz (or 3000 cycles per second), where an analog TV signal has a bandwidth of approximately 6MHz (or 6 million cycles per second) which is approximately 2000 times greater than a simple voice phone call. These units have a bandwidth of 250MHz (which is 250 million cycles per second) and that is 40 times greater than a simple TV signal. The high bandwidth allows for the transmission of large amounts of information at a very high rate of speed, thus allowing for the use of high resolution settings upwards of 1920 x 1440 in 24 or 32 bit true color mode.

Splitter boosts signal for transmission up to 215 feet away!
250MHZ Up To 1924X1440
Daisy chainable allows you to expand your video splitter set-up beyond 4 displays

Weight: 1.55
Width: 7.75
Height: 2.75
Length: 11.75