ElectroVoice ZX4-90B 15-Inch Two-Way Passive 90 Degrees x 50 Degrees , 400W Loudspeaker System, Black Finish
Electro-Voice ZX490B Features:
EVS15-SF 15" LF Transducer DH3 1.25" Voice Coil, 1" Exit Compression Driver 90 Degrees x 50 Degrees Coverage Pattern 400W Continuous (1600W) PowerHandling Selectable Monitor Angle (45 Degrees or 55 Degrees ) High Sensitivity, 132 dB Maximum SPL Lightweight 20.2 kg (44.5 lbs) Integral Pole Mount The rugged enclosure of the Electro-Voice Zx4 is perfect for portable main mix and monitor applications, while the stylish design gives it appeal in even the trendiest of environments. At only 20.2 kg (44.5 lbs), the lightweight Zx4 allows ease of transport and set up. Every detail of your music is reproduced from extended highs to powerful lows. The DH3 compression driver with its pure titanium diaphragm, coupled with the Zx4s large 90 Degrees x 50 Degrees horn allows for tremendous intelligibility and pattern control. The EVS15-SF 15" LF delivers tight, low bass and outstanding power handling capacity. Zx4 is capable as an entire system. With an integral pole mount the Zx4 is ready for main mix applications in DJ, band and general entertainment use. To accomodate different stage depths, Zx4 incorporates retractable monitor feet. This allows Zx4 to be used as a stage monitor with a 45 Degrees or 55 Degrees angle. The high tech enclosure uses injection-molded high impact polypropylene structural foam to make the Zx4 incredibly durable. The enclosure geometry elements have been carefully designed to provide maximum rigidity and bass response. Freq. Response1(-3 dB): 60 Hz - 20 kHz Freq. Range1(-10 dB): 42 Hz - 20 kHz Rec. Hipass Frequency: 42 Hz Axial Sensitivity: 100 dB (1W/1m) Max Calculated SPL: 132 dB Horizontal Coverage: 90 Degrees Vertical Coverage: 50 Degrees Rated System Power: 400W Continuous, 1600W Peak LF Transducer: EVS15-SF, 15in (381mm) Driver HF Transducer: DH3, 1in. (25.4mm) Exit Compression Driver Crossover Frequency: 1.5 kHz Nominal Impedance: 8 Ohms Minimum Impedance: 6.5 Ohms Connectors: Neutrik Speakon NL4 Enclosure Material: Polypropylene Structural Foam Suspension: Enclosure has locations for 3 SingleStud Attatchment Plates and 8 Forged Steel Eyebolts - 2 on Top, 2 on Side, and 4 on Rear of Enclosure Grille: Polyester Powder Coated, 16GA Galvanized Steel Dimensions (H x W x D): 692mm x 446mm x 411mm; (27.26" x 17.57" x 16.16")
